FA163710 Car System - chassis kit - Bus, Truck (N)
FA163710 Car System - chassis kit - Bus, Truck (N)
Make the stationary vehicle model of your choice fit for Car System.
Chassis kit to motorize stationary models of N buses and N trucks for Car System operation.
Set contains all vehicle components required for the assembly of a fully functioning two- or three-axle Car System N gauge chassis (bus and truck), except the rechargeable batteries: Motor with worm, Motor holder with worm wheel and driving axle, Driving wheels, Front axle with wheels, Steering rod with magnet, Front axle holder, Switch, Charging socket, Dry-reed sensor, Resistors to adjust the charging current.
Conversion info:
- Fastening of motor in gear unit at choice horizontal (e.g. in buses and trucks with dropped frame) or vertical (e.g. in semitrailer trucks)
- Axle bases (horizontal motor) can be selected continuously between 25 mm and 43 mm
- Axle bases (vertical motor) can be selected continuously between 20 mm and 40 mm
- Width: approx. 16 mm
Chassis kit to motorize stationary models of N buses and N trucks for Car System operation.
Set contains all vehicle components required for the assembly of a fully functioning two- or three-axle Car System N gauge chassis (bus and truck), except the rechargeable batteries: Motor with worm, Motor holder with worm wheel and driving axle, Driving wheels, Front axle with wheels, Steering rod with magnet, Front axle holder, Switch, Charging socket, Dry-reed sensor, Resistors to adjust the charging current.
Conversion info:
- Fastening of motor in gear unit at choice horizontal (e.g. in buses and trucks with dropped frame) or vertical (e.g. in semitrailer trucks)
- Axle bases (horizontal motor) can be selected continuously between 25 mm and 43 mm
- Axle bases (vertical motor) can be selected continuously between 20 mm and 40 mm
- Width: approx. 16 mm
FA163710 Car System - chassis kit - Bus, Truck (N)
Price: NZ $ 146.90
Total: NZ $ 146.90
Total without tax: NZ $ 127.74
Total discount:
GST: NZ $ 19.16
Description
Because modellers want to add vehicle bodies to the chassis, two necessary measurements are shown below:
Axle to axle - 20 - 43 mm., depending on the position of the motor.
Width - Depends upon the axle and type of wheels (single/double)
These details have been supplied to us by Faller.
Units in box: 1